Troubleshooting guide

SECTION 4
MAINTENANCE
45
2. Make sure the Printhead Cover is fully opened to retract the ink lines. Remove the Printhead
Cartridge by tilting it toward the ink lines [3], then carefully lift it out of the Printhead
Compartment.
3. Carefully pack the Cartridge using the original packaging.
Remove the Service Station
1. Open the Front Cover (hinged at bottom). Remove
the Exit Roller Cover by removing the four (4) screws.
Open the Top Cover.
Release the two latches and open the Clamshell Cover.
The Service Station will not fully eject with the Cover
Closed.
2. Open the Printer Toolbox. In the
User Interface window, press
the Eject Service Station
button. Once the Printer pushes
the Service Station out, turn the
Printer OFF.
TURN PRINTER POWER OFF.
CAUTION
WHENEVER POWERING DOWN UNIT, ALWAYS:
1. PRESS THE POWER BUTTON ON THE CONTROL PANEL.
2. WAIT FOR THE PRINTER TO STOP PROCESSING.
3. THEN PRESS THE MAIN POWER SWITCH ON THE REAR PANEL.