Troubleshooting guide

SECTION 4

MAINTENANCE

7. Close the Printhead Cover [6]. The Printer will

automatically run a start-up routine and prime the

ink into the Printhead. This may take a few

minutes. Make sure that ink is flowing through

the hoses. If air bubbles appear you may have to

tap the lines or run the Circulate Ink routine to

clear them.

8. Watch the Toolbox screen on your computer again.

Notice that some of the information is in red. As the

Printer circulates ink and primes the system these fields

should all turn black.

9. When the Printer stops processing and all the fields in

System Status are black, the Printer is ready for use.

Close the top cover.

IMPORTANT

CHECK INK TANKS. PRINTER MAY NOT FULLY

REPRIME IF TANKS ARE LESS THAN 1/3 FULL.

NOTE: The Printer may take up to 12 minutes to set itself up

during initial startup. This is normal. The machine will emit a

number of chirps, whirrs and other noises as it circulates ink

and runs systems.