Troubleshooting guide

SECTION 4
MAINTENANCE
35
WARNING
To avoid electrical shock or shorting:
Before installing the Printhead, make sure the nozzles are hydrated and the contacts are DRY!
5. Carefully insert the Cartridge into the
compartment at an angle [4], with the
Printhead surface facing down and the
Ink Nozzles facing the Ink Hoses. Once it
is seated, gently tilt the Cartridge back
until it snaps into an upright position [5].
DO NOT FORCE the Cartridge into
position.
6. Wet the Printhead Surface. This
ensures that the Printhead will prime
correctly. Open the Top Cover. Release
and lift up the two latches (one on each
side of the Printhead Assembly) at the
same time to raise the Printhead
Assembly. Moisten the Printhead
nozzles using distilled water and a
wet, lint-free cloth. Close and relatch
the Printhead Assembly.
CAUTION
OPERATE AND HOLD ONTO BOTH
LATCHES WHEN OPENING AND
CLOSING THE PRINTHEAD ASSEMBLY
TO PREVENT DAMAGE.
DO NOT ALLOW THE ASSEMBLY DROP
BY ITSELF TO CLOSE LATCHES.
TO PREVENT DAMAGE TO THE INK
LINES, A STOP LIMITS RAISING THE
ASSEMBLY MORE THAN 60°.