Troubleshooting guide

SECTION 2

INSTALLING THE PRINTER

4. Wet the Printhead Surface. This ensures

that the Printhead will prime correctly.

Open the Top Cover. Release and lift up the

two latches (one on each side of the

Printhead Assembly) at the same time to

raise the Printhead Assembly. Moisten the

Printhead nozzles using distilled water and

a wet, lint-free cloth. Close and relatch the

Printhead Assembly.

CAUTION

OPERATE AND HOLD ONTO BOTH

LATCHES WHEN OPENING AND

CLOSING THE PRINTHEAD

ASSEMBLY TO PREVENT DAMAGE.

DO NOT ALLOW THE ASSEMBLY

DROP BY ITSELF TO CLOSE

LATCHES.

TO PREVENT DAMAGE TO THE INK

LINES, A STOP LIMITS RAISING

THE ASSEMBLY MORE THAN 60°.

5. Close the Printhead Cover [6]. The Printer will run

a start-up routine and prime ink into the Printhead.

This may take a few minutes. Make sure that ink is

flowing through the hoses.

6. Watch the Toolbox screen on your computer again. Notice

that some of the information is in red. As the Printer

circulates ink and primes the system these fields should all

turn black.

7. When the Printer stops processing and all the fields in

System Status are black, the Printer is ready for use. Close

the Top Cover.

NOTE: The Printer may take up to 12 minutes to set itself up

during initial startup. This is normal. The machine will emit a

number of chirps, whirrs and other noises as it circulates ink

and runs systems.