Troubleshooting guide

SECTION 2

INSTALLING THE PRINTER

2. Take the Printhead

Cartridge you hydrated

and set aside earlier,

remove the orange cover

and proceed to Step 5.

Otherwise, follow the

Steps below:

Carefully remove the

Printhead Cartridge

from the foil packaging.

[A] Tear at notch or cut

end with scissors.

[B] Remove the

protective plastic cover.

Hold the Printhead by the

handle and unclip the

cover from the Printhead.

[C] Remove protective

strip from the Printhead

Electrical Contacts. DO

NOT allow removed strip

to touch the electrical contacts.

[D] Remove protective strip from the Printhead Nozzles. Hold the Printhead by the handle

with one hand. Pull the strip tab with the other hand and slowly peel the strip from the

Printhead. DO NOT pull the strip at any angle less than 45° with the Printhead surface.

DO NOT allow removed strip to touch the Printhead Nozzles.

IMPORTANT! Pour distilled water into the orange plastic cover you removed in Step 4B

and carefully reinstall the Printhead back into the plastic cover. Set the Printhead aside for

15 to 20 minutes. This rehydrates Printhead and allows easier priming once it is installed in

the Printer.

WARNING

To avoid electrical shock or shorting:

Before installing the Printhead, make sure the nozzles are hydrated and the contacts are DRY!

3. Carefully insert the Cartridge into the compartment at an angle [4], with the Printhead surface

facing down and the Ink Nozzles facing the Ink Hoses. Once it is seated, gently tilt the Cartridge

back until it snaps into an upright position [5]. DO NOT FORCE the Cartridge into position.