Service manual

SECTION 1

INSTALLATION

Section 1 - Installation

Unpacking the AstroJet 2600P/2650P/2800P

Tools required Standard #2 Phillips head screwdriver.

1. Remove accessories from feed area of printer.

2. Remove foam blocks from printhead area.

Attach the Side Guides to the Printer

1. Remove the two screws from the side guide blocks.

2. Position the side guide screw holes so that they align

with the holes in the side guide blocks.

3. Insert the screws removed in step 1 and tighten them

so that the guides are firmly attached to the side guide

blocks.

Choose a Location

The AstroJet 2600P/2650P/2800P should be placed on a sturdy worktable or cabinet at least 12 inches from any

walls. Protect the AstroJet 2600P/2650P/2800P from excessive heat, dust, and moisture – avoid placing it in

direct sunlight.

Connecting the AstroJet 2600P/2650P/2800P

Plugging in the Printer

Make sure that the main power switch of the AstroJet 2600P/2650P/2800P Printer is in the OFF position.

1. Connect one end of the power cord to the rear of the

AstroJet 2600P/2650P/2800P in the corresponding

receptacle.

2. Depending on the version 115 volt or 220 volt, plug

the other end into a 115 or 220 Volt AC, 50/60 Hz.

Grounded outlet.

CAUTION

DO NOT USE AN ADAPTER PLUG OR

EXTENSION CORD TO CONNECT THE

PRINTER TO THE WALL RECEPTACLE.

DO NOT USE OUTLETS CONTROLLED BY

WALL SWITCHES.

DO NOT USE AN OUTLET THAT SHARES

THE SAME CIRCUIT WITH LARGE

ELECTRICAL MACHINES OR

APPLIANCES.