Service manual

SECTION 5
DISASSEMBLY – ASSEMBLY
39
8. Continue disassembly by removing the ground screw and ground wire from the carriage assembly.
9. Then remove the two screws [4] that attach the
carriage support bracket on the non-operator side.
10. Continue the disassembly by removing the mounting
bracket on the operator side by removing the three
screws [5]. You may find it necessary to remove the
shield around the print head assembly by removing the
four screws [6], also.
11. Slide the printhead assembly out of the machine from
the operator’s side. Take care that the ribbon cables
are not damaged during this process. If you remove
the exit roller-mounting bar and exit rollers, the task
will be easier.