Service manual

SECTION 5

DISASSEMBLY – ASSEMBLY

NON-OPERATOR SIDE COVERS

1. Remove the two screws at the top of the left hand non-

operator side cover. Then remove the two screws

from the bottom of the cover.

2. Remove the cover.

3. Remove the two screws at the top of the right hand

non-operator side cover. Then remove the two screws

from the bottom of the cover. The Interface PC Board

[A] is under this cover.

NOTE: The AstroJet 2600P is shown. The same

procedure is used for the AstroJet 2800P

4. Remove the cover. Do not pull it too far away as the

cable from the printer port is connected to the Main

Processor PC Board [B]. Disconnect this cable from the PC Board and set the cover aside.

5. The two PC Boards under these covers are attached to

the machine by four screws each. Unplug the

connectors and then remove the screws to remove the

PC Boards.

INTERFACE PC BOARD 2600P and 2800P

1. CLUTCH

2. SPEED CONTROL

3. INTERLOCK – Safety Switch

4. CONV. – Conveyor Interface

5. CONTROLLER

6. MEDIA SENS.

7. 15VDC IN – Power input for Interface

PCB.