Service manual

SECTION 4
ADJUSTMENTS
29
ASTROJET 2600P/2650P/2800P Brake Adjustment
REQUIREMENT: To provide the proper tension on the feed shaft brake assembly for proper
feeding of the media.
ADJUSTMENT:
1. Disconnect the Printer from the power source.
2. Remove the Operator side cover, Non-Operator
side cover and rear cover.
3. Reconnect the printer to the power source and
turn it ON.
4. Turn the brake tension adjusting screw [1]
clockwise until the brake exerts a drag on the
feed rollers.
5. Load # 10 envelopes and turn the printer ON.
Press the TEST PRINT key, then the
ENTER key to start the feeding the media.
Observe that only one piece of media feed at a
time.
NOTE: If more than one piece feeds at a
time increase the tension by turning the
screw clockwise. If the machine slows
down, decrease the tension by turning the
screw counterclockwise.
6. Turn off the printer, disconnect from the
power source and replace the covers.