Troubleshooting guide

SECTION 2

INSTALLING THE PRINTER

SECTION 2 – Installing the Printer

Before using the Printer:

 Choose a location for Printer

 Plug in Printer and connect it to computer

 Install Inkjet Cartridges

 Set up feed on Printer

 Install Astrojet 1000P Printer Driver and BIOS Manager software on the computer

Choose a Location

Printer should be placed on a sturdy worktable or cabinet at least 12 inches from any walls. Protect

Printer from excessive heat, dust, and moisture – avoid placing it in direct sunlight.

Connecting Printer

Plugging in Printer

Make sure that Printer’s Main Power Switch is turned OFF.

1. Connect one end of the power cord to the

rear receptacle on the Printer.

2. Plug the other end into a 115-220 Volt

AC, 50/60 Hz. grounded outlet.

CAUTION

DO NOT USE ADAPTER PLUGS OR

EXTENSION CORDS TO CONNECT THE

PRINTER TO THE WALL OUTLET.

DO NOT USE OUTLETS CONTROLLED

BY WALL SWITCHES.

DO NOT USE OUTLETS THAT SHARE

THE SAME CIRCUIT WITH LARGE

ELECTRICAL MACHINES OR

APPLICANCES.

Connecting to Computer

Plug the Parallel Printer Cable from your computer

into the rear receptacle on the Printer. Latch the two

locking clips. Cable used to connect the Printer to

the computer must not exceed 6 feet long.

NOTE: Parallel Port may be used for all versions

of Windows. USB Port is used only for Windows

XP and later versions.