Troubleshooting guide

SECTION 2
INSTALLING THE PRINTER
6
Install Inkjet Cartridges
Printer can be configured with 5 Inkjet Cartridges. To install the Cartridges:
1. Remove Inkjet Cartridge from packaging,
taking care not to touch copper contacts,
metal plate, or gold printhead. Remove
protective tape from Printhead.
2. Open Latch Lever mounted on Inkjet
Cartridge Holder.
3. With Cartridge’s Printhead pointing
down, slide Cartridge into Holder. Push
down and toward contacts in Holder.
4. Make sure Cartridge is seated in Holder.
Close Latch Lever to secure Cartridge.
DO NOT force Latch Lever into place.
(See diagram.)
5. Repeat Steps 1-4 for remaining
Inkjet Cartridges.
Ink in the cartridge may be harmful if
swallowed. Keep new and used cartridges
out of reach of children. Discard empty
cartridges immediately.
Setting up Feed
1. Release Separator Locking Lever located on
operator’s side of Feeder. Raise Separators
and lock in position. Move Side Guides to
outermost open position. Place one piece of
media in center of Feed Table.
2. Four Separators on Feeder. Use the two
Center Separators for narrow media and all
four Separators for wide media. Place the
media under the Separators and lower the
Separators so that they rest on the media.