Specifications

30
There is an optional feature on the Control Panel of the Printer that permits you to disable the break
function. See the section on “Printer Settings” for more information.
Feeder Settings
In order to permit enough time or
space between pieces to assist in
drying the ink or to help the
operator to handle the piece more
efficiently. The Feeder Settings…
button is provided. When you click
on it the following screen appears.
Click on “Should Feeder Delays
be enabled?” to activate the
feature. Then select either
seconds or inches and place a
number in the box provided. The
default is 5.5 inches. Click OK to
complete the process.
When activated there will be a
delay between the feeding of each
piece regardless of the resolution
of the print selected.
Align Heads
When printing addresses and particularly logos that stretch across several heads, it may be necessary
to adjust the alignment of the printheads to fine-tune the image. The Align Print Heads function has
the ability to achieve this
alignment, producing a straight line
across multiple heads. The
software can change the printing
offset in fine increments from its
factory settings.
NOTE: Make sure the object
or address being printed is
aligned in the layout using
the Alignment Tool on the
Setup Screen in the AstroJet
Layout Editor before you use
this procedure. This
procedure is only for very
fine adjustments and will not
correct gross misalignment
on the Setup Screen.
1. Turn the printer ON and
open the Control Panel.
Select Properties… Then
select the Align Heads tab.