SOFTWARE SP-8848 User Manual

Chapter 2 Operation
27
DOTS: Dot pattern
This button is used to set the dot pattern.
The dot pattern is always displayed after the screen center has been calculated. The screen center can be calculated
when the number of display dots and number of display lines are odd numbers. However, when they are even numbers,
the actual screen center will be one dot to the right and one line below the center. An error results when 0 is set for both
H and V.
Mode Specification as a number of lines (line) or dot intervals (dot) is selected here
as the mode setting.
Format The save start point (From Center or From Top Left) is selected here.
Interval The number of lines (when "line" has been selected) or the dot interval (when
"dot" has been selected) of the dot pattern is set here.
Dot size The dot size is set here.
Dot type The type of dots is set here.