SOFTWARE SP-8848 User Manual

4
4
Error message reference
Error message Code
(HEX)
Description of error
Panel ROM Unsetted 00 The EE-PROM has not been inserted into the panel ROM socket or the
memory card has not been installed.
Prog No Disabled 01 The number of the program which was input turns out to have been set
to "Disable" when direct display or a program is executed.
DotClk over 02 DotClock in the horizontal timing data is outside the specified range.
Hfp over 03 The front porch in the horizontal timing data is outside the specified
range. (Hperiod ?>=? Hsync + Hbackp + Hdisp)
HD over 05 HDstart + HDwidth in the horizontal timing data is outside the specified
range. (Hperiod ?>=? HDstart + HDwidth)
Hperiod over 07 HPeriod in the horizontal timing data is outside the specified range.
Hdisp over 08 Hdisp in the horizontal timing data is outside the specified range.
Hsync over 09 Hsync in the horizontal timing data is outside the specified range.
Hbp over 0A Hbackp in the horizontal timing data is outside the specified range.
Hblank over 0B The blanking period in the horizontal timing data is outside the specified
range.
Hfreq over 0C The horizontal frequency in the horizontal timing data is outside the
specified range.
H-TIM data NG 0D Error other than those described above in the horizontal timing data.
OUTPUT data error 10 Error in the output condition data.
CHR data error 11 Error in the CHARA pattern data.
CROSS data error 12 Error in the CROSS pattern data.
DOTS data error 13 Error in the DOTS pattern data.
CRCL data error 14 Error in the circle pattern data.
BRST data error 15 Error in the burst pattern data.
WIND data error 16 Error in the window pattern data.
COLBAR data error 17 Error in the color bar pattern data.
PARAMETER error 18 Error in a parameter in the terminal mode.
DATA error 19 Error in the data in the terminal mode.
SYNC data error 1A The sync signal has not been set.
COMM. Timeout 1E Time-out has occurred during communication in the terminal mode.
Undef Command 1F An undefined command was received in the terminal mode.
V-Sync Timeout 20 Time-out has occurred during V sync interrupt wait.
Prog-NO error 21 Error in the program number.
Group-NO error 22 Error in the group number.
User-CHR code error 23 Error in a user character code.
EEPROM write error 24 An EEPROM write error has occurred.
M-Card Type error 25 The memory card is not the correct type.
M-Card Write error 26 A memory card write error has occurred.
M-Card W-Protected 27 The memory card has been set to the write protect status.
M-Card Not Set 28 The memory card has not been installed.
M-Card UnFormated 29 The memory card has not been formatted.
M-Card Full 2A There is no free space on the memory card.
OPT PTN No error 2B Error in the optional pattern number.
117