SOFTWARE SP-8848 User Manual

Text setting screen
No. Item Details
①
V-chip setting display This button is used to display the V-chip setting screen.
②
CC mode settings These are used to select closed caption mode 1, 2, 3 or 4 or text mode 1, 2, 3 or
4. When a text mode has been selected, the text setting screen is displayed.
③
Tool buttons Load: Press this to load the data from a file.
Save: Press this to save the edited data in a file.
Send: Press this to send the edited data to the VG generator, and register it in the
generator.
Receive: Press this to receive data from the VG generator.
Execute: Select UserNo. from the registered ClosedCaption data and execute it.
④
UserNo The pattern number of the sent or received text data appears here.
⑤
ArticleName The article name appears here.
⑥
Text Input the Text data. The text data should be ASCII letters of 20h to 7Fh.
Control data cannot be inputted. Use binary editor when inputting the control
data. *1
⑦
Binary settings Check it and the buttons can be selected. Press the button and the binary editor
starts. The setting Caption data is binary-displayed. On the contrary, the value
that is edited by the binary editor can be set in the editor. If Binary is checked,
caption data input editor cannot be used.
⑧
Help This is pressed to display the help information.
⑨
Close This is pressed to close the program.
*1 If a Text editor performs the reorganization collection of a character code after editing a control code by the
binary editor, all the control codes that exist in the Caption data which carried out the reorganization collection
will be deleted.
110