Specifications

./4%$)!'2!-3),,5342!4)/.3!2%./44/3#!,%
9
)../6!4)6%(%!24(02/$5#43s$)2%#46%.4'!3&)2%0,!#%3-ONTEBELLO$,8-ONTEBELLO$,8#$s).34!,,!4)/.).3425#4)/.3
TYPICAL INSTALLATION SEQUENCE
4HETYPICALSEQUENCEOFINSTALLATIONISOUTLINED
BELOW(OWEVEREACHINSTALLATIONISUNIQUEAND
MAYRESULTINVARIATIONSTOTHESTEPSDESCRIBED
3EETHE0AGENUMBERSREFERENCESINTHEFOLLOW-
ing steps for detailed procedures.
Step 1. (Page 9) Construct the appliance
framing. Position the appliance within
the framing and secure with nailing
BRACKETS
Step 2. (Page 11) Route gas supply line to the
right side.
Step 3. (Page 12) Install the vent system and
EXTERIORTERMINATION
Step 4. (Page 21) Connect 120 VAC electrical
power to the appliance receptacle.
Step 5. (Page 23) Remove glass door assem-
BLY
Step 6. (Page 23) -AKE CONNECTION TO GAS
supply.
Step 7. (Page 23) Verifying appliance opera-
tion.
Step 8. (Page 24))NSTALLlREBOXLINERPANELS
LOGSANDGLOWINGEMBERS
OR
 CONTEMPORARYBURNERmOORKITPORCE-
lain panels, and media.
Step 9. (Page 26))NSTALLGLASSDOORASSEMBLY
Step 10. (Page 26) !DJUST BURNER TO ENSURE
proper flame appearance.
Step 11. (Page 29) Attach safety in operation
warnings.
Left Side Front Corner of Fireplace Shown
(Right Side Requirements the Same)
Unit Being Secured By Its Nailing Flanges
To The Framing
NOTE: The nailing flanges, combustible members and
screw heads located in areas directly adjacent to
the nailing flanges, are EXEMPT from the 1/2” clear-
ance to combustible requirements for the firebox
outer wrapper. Combustible framing may be in direct
contact with the nailing flanges and may be located
closer than 1/2” from screw heads and the firebox
wrapper in areas adjacent to the nailing flanges.
Frame the opening to the exact dimensions speci-
fied in the framing details of this manual.
Unit Being Secured by Its Nailing
Flanges to the Framing
Unit Being Secured by Its Nailing
Flanges to the Framing
Note: The nailing flanges
, combustible members
and screw heads locat
ed in areas directly ad
jacent
to the
nailing flanges, are
EXEMPT from the 1/2”
clearance to combustible requirements for th
e
firebox outer wra
pper
. Combustible framing
may be
in
direct contact with
t he nailing flanges and
m
ay
be located closer than 1/2” from screw heads and
the firebox
wrapper in areas adjace
nt to the nailing
flanges. Frame th
e
opening to the exact dimens
ions
specified in the framing det
ails of this manual.
Use T
op Flange For
1/2” Thick Dr
ywal
l
Use Bottom Flange Fo
r
5/8” Thick Dr
ywal
l
Front Of
Fireplace
Use Center Flange
For Flush Mount
Left Side Front Co
rner of Fireplace Shown
(R
ight Side Requirements the
S ame)
Unit Being Secured By Its Nailing Flanges
To The Framing
Step 1. FRAMING
&RAMETHESEAPPLIANCESASILLUSTRATEDINFigure
11 on Page 10, UNLESSTHEAPPLIANCEISTOBE
installed in a corner. See Figure 12 on Page
11 for corner framing installations. All framing
details must allow for a minimum clearance to
COMBUSTIBLE FRAMING MEMBERS AS SHOWN IN
Table 5 on Page 8.
)FTHEAPPLIANCEISTOBEELEVATEDABOVEmOOR
LEVEL A SOLID CONTINUOUS PLATFORM MUST BE
CONSTRUCTEDBELOWTHEAPPLIANCE
(EADERS MAY BE IN DIRECT CONTACT WITH THE
APPLIANCETOPSPACERSBUTMUSTNOT BE SUP-
PORTEDBYTHEMORNOTCHEDTOlTAROUNDTHEM
!LLCONSTRUCTIONABOVETHEAPPLIANCEMUSTBE
self-supporting, DO NOT use the appliance for
structural support.
4HE lREPLACE SHOULD BE SECURED TO THE SIDE
FRAMING MEMBERS USING THE UNITgS NAILING
mANGESONETOPANDBOTTOMONEACHSIDEOF
THElREPLACEFRONTSEEFigure 10). 5SEDNAILS
ORTHEIREQUIVALENT
Figure 10
DETAILED INSTALLATION STEPS
The appliance is shipped with all gas
controls and components installed and pre-
wired.
 2EMOVETHESHIPPINGCARTONEXPOSINGTHE
front glass door on the valve access side.
2. Using a Phillips screwdriver, unfasten two
SCREWSLOCATEDATTHETOPOFTHEGLASS
FRAMEsee Figure 46 on page 26). Tilt the
top of the glass frame away from the unit.
,IFTITCAREFULLYOFFTHEBOTTOMDOORTRACK
and set the door aside, protecting it from
inadvertent damage.
WARNING
Failure to position the parts in
accordance with these diagrams
or failure to use only parts specifi-
cally approved with this appliance
may result in property damage or
personal injury.
AVERTISSEMENT
Risque de dommages ou de
blessures si les pièces ne sont
pas installées conformément à
ces schémas et ou si des pièces
autres que celles spécifiquement
approuvées avec cet appareil sont
utilisées.