Specifications

12
./4%$)!'2!-3),,5342!4)/.3!2%./44/3#!,%
)../6!4)6%(%!24(02/$5#43s$)2%#46%.4'!3&)2%0,!#%3-ONTEBELLO$,8-ONTEBELLO$,8#$s).34!,,!4)/.).3425#4)/.3
RESTRICTOR
APPLIANCE VENT OUTLET
When vertically terminating the vent system above
the roof, install a vent restrictor in the top vent of
the fireplace outlet. Install the restrictor as shown
from inside the unit, in the inner fireplace collar
Figure 14—Vent Restrictor Installation
Step 3. INSTALL THE VENT SYSTEM
General Information
These instructions should be used as a guide-
line and do not supersede local codes in any
way. Install vent according to local codes,
these instructions, the current National Fuel
Gas Code (ANSI-Z223.1) in the USA or the
current standards of CAN/CGA-B149.1 and
-B149.2 in Canada.
Ensure clearances are in accordance with
local installation codes and the requirements
of the gas supplier.
Dégagement conforme aux codes
d'installation locaux et aux exigences du
foumisseunde gaz.
Use only approved venting components.
See Approved Vent Components on
Page 2.
These fireplaces must be vented directly
to the outside.
The vent system may not service multiple
APPLIANCESANDMUSTNEVERBECONNECTEDTOA
mUESERVINGASEPARATESOLIDFUELBURNINGAP-
PLIANCE4HEVENTPIPEISTESTEDTOBERUNINSIDE
ANENCLOSINGWALLSUCHASACHASE4HEREIS
NOREQUIREMENTFORINSPECTIONOPENINGSINTHE
ENCLOSINGWALLATANYOFTHEJOINTSINTHEVENTPIPE
Installation of Vent Restrictor
! VENT RESTRICTOR MAY BE NEEDED WITH THIS
appliance. The restrictor is installed in the
appliance top flue outlet as shown in Figure 14,
For vertical venting from 6 feet to 12 feet or
more, from the top of the fireplace to the top
of the termination, the installation of a vent
restrictor is required.
If necessary, install a vent restrictor in the
appliance flue outlet as shown in Figure 14. The
VENTRESTRICTORISHELDINPLACEBYFRICTIONONLY
NOTE: The restrictor is included within the
firebox.
Select Venting System—Horizontal or Vertical
7ITH THE APPLIANCE SECURED IN FRAMING DE-
TERMINEVENTROUTINGANDIDENTIFYTHEEXTERIOR
termination location. The following sections
DESCRIBEVERTICALROOFANDHORIZONTALEXTERIOR
WALLVENTAPPLICATIONS2EFERTOTHESECTION
relating to your installation. A list of approved
venting components is shown on Page 30.