Assembly & Installation Instructions

Post Cap
Stem
Fixture Wire
Wire Nut
Set Screw
Post
Washer
1. Pull out the wires and grounding wire from the post.
Make wire connections using the wire nuts:
---The black wire from the fixture to the black wire
from the post.
---The white wire from the fixture to the white wire
from the post.
---The grounding wire from the fixture to the grounding
wire from the post.
Carefully put the wires back into the post.
2. Place the post cap on the post, then secure it with the
set screws.
CAUTION: With silicone caulking compound, caulk
completely around where the post cap meets with
the post surface to prevent water from seeping into
the post.
4. Attach the candle tubes to the sockets, then install a bulb
(not included). See relamping label at socket area or
packaging for maximum allowed wattage.
5. Attach the dome to the frame by inserting the stem, then
secure it with the finial.
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
3. Screw the finial and take the dome out.
3. Turn on the power at the main fuse or circuit breaker box.