Installation & Assembly

Thread the lead wires and ground wire (first) through the ring and then the canopy.
Thread the wires up through alternating links of the chain to the outlet box.
5. Measure 6" of lead wire beyond the end of the chain. Cut off excess wire.
Strip the insulation off the ends of the leads exposing approx. 1/2 " of wire.
Twist the strands of wire together. Push the leads and ground wire up
through the screwcollar loop and nipple and into the outlet box.
6. Fasten the ground wire to the green or bare copper wire
in the outlet box or to the green screw on the crossbar.
WARNING
Never fasten the ground wire to the black or "hot" wire!
Failure to follow this instruction could result in
serious injury or death!
7. Fasten the white fixture lead to the white wire in the outlet box.
Fasten the wires together with an approved fastener (wire nut).
Starting about 1' below the fastener, tightly wrap the connection
with electrical tape so that the connection seals the end of the fastener.
WARNING
Make sure that there is no exposed wire or strands that
could cause a dangerous short circuit !
8. Connect the black fixture lead to the black wire in the outlet box.
Fasten the joined wires as in step 7
9. Slide the canopy and screwcollar ring up the chain.
Secure the canopy to the ceiling.
10. Remove the knurled round nut and rubber washer from the bottom of the cage.
Remove the lower half of the cage.
11. Install the lamps ( light bulbs). NOTE: This fixture is rated for
Max 60 watt type B, BA, C or CA lamps .
WARNING
DO NOT EXCEED RECOMMENDED WATTAGE!
12. Place the glass globe onto the lower half of the cage.
Lift the cage into position and secure using the rubber washer and knurled round nut.
13. Thread the finial onto the bottom of the fixture.
14. Restore power to circuit at breaker or fuse box.
electrical tape
approved fastener
(
wire nut
)