Technical data

ASTi ACE Studio Cold Start Procedure (Ver. 2, Rev. J)
Copyright © 2011 Advanced Simulation Technology inc. 7
4.2. Installing ACE Studio Software
The following steps are for software versions 4.5 and above.
Note: To install ACE Studio on a virtual machine see the ACE Studio VM Quick Start Guide
(DOC-01-ASVM-QSG-4).
Before proceeding with this installation, complete section 4.1. Installing RHEL Software.
1. Login with:
username: root password: abcd1234
2. Insert the ASTi DVD.
3. To open the terminal navigate to Applications > Accessories > Terminal.
4. To mount the DVD type the following in the terminal:
mount /dev/dvd /media
5. At the prompt type:
sh /media/install
6. The prompt will read, ‘Select a product to install.’ Use the up and down
arrow keys to select ‘ACE Studio’. Then using tab or right arrow key select ‘OK’.
Note: Screen may vary depending on software version.
7. Prompt will read, ‘Do you wish to install ACE Studio?’ Select ‘Yes’ and
wait for the installation to complete.
8. Then type:
eject /media
9. Remove the DVD from the drive.
10. Type:
reboot
to reboot the system.