Technical data

ASTi Telestra 4 Quick Start Guide (Ver. 1, Rev. E)
Copyright © 2011 Advanced Simulation Technology inc. 11
4.0. Setting up the Audio Distribution Hardware
To complete the set up you will need the following hardware:
• ACU2, ACU, or ACE-RIU
• Power supply
• ACE Studio Development Workstation
• Category 5e cable or better
•ACENet switch
Follow the steps below to set up the ACENet audio distribution device.
1. Using a Category 5 cable connect the ACENet switch to the Ethernet port on the device.
Note there are two Ethernet ports on the ACU, select either one.
ACEnet ACEnet
Power
ACU Status
Indicators
ACENet Ports
Channel Status
Indicators
Serial Ports
ACU Rear Panel
Serial Ports
A
B
Status
Power
+15VDC
1 2 3 4
ACENet
ACENetSerial Ports
Power
Status
ACE-RIU Rear Panel
Serial Ports
2
1
Status
Power
In
+15VDC
1 2 3 4
ACENet
Power
Out
Power Serial Ports ACENet
Status Indicators
ACU2 Rear Panel
2. Power on the device.
3. Using a Category 5 cable connect th
e ACENet switch to eth1 on the Target. See Top Level
Hardware Layout on page 1.