Technical data

ASTi Telestra 4 Quick Start (Ver. 1, Rev. E)

2.0. Setting up the ACE Studio Development Worksta-

tion

To complete the set up you will need the following hardware:

• monitor

• keyboard

• mouse

• power supply (if using a small footprint computer system)

• ACE Studio Development Workstation

• Category 5e cable or better

• Network connection from ACE Studio to Target

Follow the steps below to setup the ACE Studio Development Workstation and assign an IP

address to the system. The ACE Studio Development Workstation will not have an IP address

without a DHCP network connection.

1. Connect the monitor, keyboard, mouse, and power supply to the development workstation.

2. Connect the development workstation to the same network as the Target.

3. Power on the development workstation and allow it to boot.

The development workstation will not have an IP address without a DHCP network con-

nection.

4. In the top left corner select System > Administration > Network.