Technical data

ASTi Telestra MBV Quick Start Guide (Ver.2 Rev. C)
2 Copyright © 1999-2008 Advanced Simulation Technology inc.
2.1.1. Restoring a Configuration
If you have an archived configuration, you may want to restore this configuration instead of start-
ing from scratch. After setting the IP address for eth0, navigate to a workstation on the network
with a local web browser. Type the IP address in the web browser address bar as follows:
http://xxx.xxx.xxx.xxx/
where “xxx.xxx.xxx.xxx” is the IP address previously assigned to eth0 using the Telestra Config-
uration Utility.
Navigate to the RMS Telestra >> Actions page and select “
Restore System Configuration .”
Select the “Choose File” button and navigate to find the backup file. Then select the “Upload
Backup File.”