Technical data

ASTi Telestra MBV Quick Start Guide (Ver.2 Rev. C)

2.3. Creating a new User Account

Now you are ready to get RMS up and running.

1. Open up a web browser on a computer that is connected to the

same network as the Telestra.

Note

: A quick test to conﬁrm the computer is running on the

same network is to use the standard networking “ping” com-

mand from your browser computer, use ping <telestra IP

address>.

In the web browser's address ﬁeld type in the IP address of the

Telestra you just recorded in step 4.

2. You will be presented with a Login Screen that requests a

username and password. Use the ASTi default username:

Username: rmsuser Password: astirules

All user account logins and passwords are case-sensitive.

The default Telestra user accounts (mbvuser and rmsuser) are

relied upon for proper system operation.

Users should never

delete these accounts.

Note As of software version 3.27-1 the

rmsuser account can be deleted for security purposes.

If performing model development in MBV on this Telestra,

ASTi recommends creating a new user account for accessing

both the development environment and RMS interface.

Change your password!

Since each RMS is shipped with the

same default password, this affords virtually no security for your system. Changing your

user accessing your system.

Remember your password!

If you forget your new password, the only way to recover the

system (i.e., restore the factory default) is to reinstall the Telestra software via the Cold

Start Procedure (DOC-01-TELS-CS-3).

Note: Your network or systems administrator may enforce a User ID and/or password

policy for security purposes. Check with the network manager before proceeding.

If you are using MBV software version 3.26-4 or earlier continue with the step three below.

If you are using MBV software version 3.27 or after skip ahead to section 2.2.1