Technical data

DOC-01-TELAS-CRG-4 ASTi ACE Studio Components Reference Guide Rev.M
66 Copyright © 2014 Advanced Simulation Technology inc.
FreqMod-
Depth
Type Default Value
float32 1.0
Description: Frequency modulation depth value, controls the effect
of the frequency modulation signal:
ActualFreq = Freq x (1+ (ModDepth x ModSignal))
Usually it falls in the range of 0 to 1.0, when used in conjunction
with a unity gain modulation signal. If no external variable is con-
nected to FreqModDepth, the value of the scaler is used as the fre-
quency modulation depth.
Note: To avoid unpredictable behavior care should be taken to
ensure that the product of modulation depth and modulation signal
does not span a range greater than -1.0 to +1.0.
Modifier: Multiply
Modifier_default: 0.0
Range: 0.0 - 1.0
Gain
Type Default Value
float32 1.0
Description: Amplitude gain of the waveform. If no external vari-
able is connected to Gain, the value of the scaler is used.
Modifier: Multiply
Modifier_default: 0.0
Range: 0.0 - Inf
Control Inputs
MarkSpa-
ceInput
Type Default Value
float32 1.0
Description: The mark/space input controls the duration the square
wave is on, the plus side relative to the period of the wave. (e.g. a
value of 0.5 means in a given period, the square wave output will be
+Gain for half of the time and -Gain for the other half). If no exter-
nal variable is connected to MarkSpace, the value of the scaler is
used.
Modifier: Multiply
Modifier_default: 0.5
Range: 0.0 - 1.0
Audio Output
OutSignal
Type Default Value
audio n/a
Description: OutSignal is the output signal from the Wave compo-
nent, which maybe connected to another component or directed to
an output gateway.
Internal Parameters
Mark-
SpaceUnits
Type Default Value
width_units duty_cycle
Description: This parameter is for the pulse and square inverse and
defines the units for mark space input.
The duty cycle range is 0-1.
The value can also be set in seconds.
Control Inputs