Technical data

ASTi ACE Studio Components Reference Guide Rev. M DOC-01-TELAS-CRG-4
Copyright © 2014 Advanced Simulation Technology inc. 45
Control Input
Sweep
Time
Type Default Value
float32 0.0
Description: Provides the length of the sweep that the pulses are
contained in, in microseconds. See the figure above for details.
Note 1: If the PaintTimes flag is set to fractional, this field will be a
frequency in hertz.
Note 2: The timing resolution of the sweep time is 1/sample rate. For
a sample rate of 8kHz, the resolution is 125 microseconds.
Internal Parameters
Amplitude
Type Default Value
float32 0.0
Description: Provides the height of each pulse. Each pulse height
should be between 0 and 1.
Delays
Type Default Value
float32 0.0
Description: Provide the delay, for each pulse, between the begin-
ning of the sweep and the beginning of each pulse. If a pulse delay
puts a pulse outside the sweep, that pulse will not be generated.
Note: The resolution of the Delays is 1/sample rate. For a sample
rate of 8kHz, the resolution is 125 microseconds.
Internal Parameters
Paint
Times
Type Default Value
pulse_step_mode Fixed
Description: This is a flag which is set either to Fixed or Fractional.
If set to Fixed, the sweep time, delay times, and durations are all
measured in microseconds.
If set to Fractional, the sweep is a frequency in hertz, and the Dura-
tions and delays are specified as a fraction of the sweep time.
Audio Outputs
OutSignal
Type Default Value
audio n/a
Description: OutSignal is the output signal from the component,
which may be connected to another component or directed to an out-
put highway.