Technical data

ASTi ACE Studio Components Reference Guide Rev. M DOC-01-TELAS-CRG-4
Copyright © 2014 Advanced Simulation Technology inc. 11
Internal Parameters
Level
Table
Type Default Value
function n/a
Description: Select a TableXY from the Math Plan. This table
should contain the measured signal levels for each test. These val-
ues can be copied from the /tmp/autodred.dat file following a setup
run.
Mode
Type Default Value
dred_mode STOP
Description: Reports the current state of the component. Options
include:
•Stop
•Test
• Manual Test
• Setup
NoiseGain
Type Default Value
int32 0
Description: Controls the gain for pink noise tests.
Result1
Type Default Value
float32 0
Description: The output of Result1 is the audio level for all speak-
ers at once.
Internal Parameters
Result2
Type Default Value
float32[16] 0
Description: The output of Result2 is the audio level per speaker
starting with 0.
Result3
Type Default Value
float32[16] 0
Description: The output of Result3 is the audio level per speaker
starting with 0.
Result4
Type Default Value
float32[16] 0
Description: The output of Result4 is the audio level per speaker
starting with 0.
Result5
Type Default Value
float32[16] 0
Description: The output of Result5 is the audio level per speaker
starting with 0.
Threshold
Table
Type Default Value
function n/a
Description: Select a TableXY from the Math Plan. This table con-
tains the failure thresholds for each individual test. Values are in dB.