Technical data

DOC-01-TELAS-CRG-4 ASTi ACE Studio Components Reference Guide Rev.M
10 Copyright © 2014 Advanced Simulation Technology inc.
Control Outputs
Channel
Type Default Value
uint8 0
Description: Assign each bus 1-16 to intercom buses in the model.
Error-
Code
Type Default Value
uint32 0
Description: Displays the number of the speaker that fails. This
number will appear until Test Enable is reset.
LevelDif-
ference
Type Default Value
Float32 0
Description: Decibel difference between the last channel tested and
the reference value that was created during the initial setup proce-
dure.
TestCase
Type Default Value
uint8 0
Description: Use this with manual enable to specify the test.
1 - Sends pink noise to all speakers.
2 - Sends a sinewave at 100Hz to each individual speaker.
3 - Sends a sinewave at 1,000Hz to each individual speaker.
4 - Sends a sinewave at 10,000Hz to each individual speaker.
5 - Sends pink noise to each individual speaker.
Control Outputs
TestRun-
ning
Type Default Value
boolean False
Description: The currently running test, if there is an error this field
displays the test that failed. This test will appear until TestEnable is
reset.
Time
Type Default Value
float32 0.0
Description: Amount of time the test has been running.
Internal Parameters
Back-
ground
Level
Type Default Value
float32 0.0
Description: The measured RMS level for the background noise
test.
Filter-
NoiseGain
Type Default Value
float32 1.0
Description: Filters the gain for pink noise tests.
GainTable
Type Default Value
function n/a
Description: Select a TableXY from the Math Plan which is used to
adjust the audio gain for each individual test. For example, this
could be used to boost the low frequency noise volume for a sub-
woofer test.