Technical data

ASTi ACE Studio Components Reference Guide Rev. M DOC-01-TELAS-CRG-4
Copyright © 2014 Advanced Simulation Technology inc. 9
Control Inputs
Case
Duration
Type Default Value
float32 0.0
Description: The amount of time sounds are played for each test
case.
Num-
Channels
Type Default Value
int32 0
Description: Set this value to the number of speakers in the system
setup. Limit is 16 channels.
Setup
Enable
Type Default Value
boolean true
Description: If set to true, the AutoDred component initiates the
automated setup procedure. This may take a few minutes depending
on the number of channels, approximately 2 minutes per channel.
Test2Freq
Type Default Value
float32 100.00
Description: Sets the frequency for test 2.
Test3Freq
Type Default Value
float32 1,000.00
Description: Sets the frequency for test 3.
Test4Freq
Type Default Value
float32 10,000.00
Description: Sets the frequency for test 4.
Control Inputs
TestCase
Select
Type Default Value
uint8 0
Description: Use this with manual enable to select the test.
1 - Sends pink noise to all speakers.
2 - Sends a sinewave at 100Hz to each individual speaker.
3 - Sends a sinewave at 1,000Hz to each individual speaker.
4 - Sends a sinewave at 10,000Hz to each individual speaker.
5 - Sends pink noise to each individual speaker.
Test
Enable
Type Default Value
boolean false
Description: Set to true to begin tests 1-5.