Technical data

DOC-01-TELAS-CRG-4 ASTi ACE Studio Components Reference Guide Rev.M
136 Copyright © 2014 Advanced Simulation Technology inc.
9.6. AudioIO > SpeakerOut
Summary: Retrieves audio from the Highways 3D soundfield that is intended for a
speaker at the specified X, Y, Z position.
Description: SpeakerOut creates a speaker in the Highway 3D Service with the
specified X, Y, and Z coordinates relative to the soundfield reference point,
extracting the audio from the service for the speaker. The X, Y, and Z position
should correspond to the speaker’s physical location. Typically, the AudioOut is
linked directly to an AmpOut component’s audio out.
For example, if using an eight channel crown amp to drive an 8 speaker setup, the
model should contain 8 SpeakerOuts linked to 8 AmpOut components.
Control Input
Gain
Type Default Value
float32 n/a
Description: A gain applied to the audio output.
Audio Output
AudioOut
Type Default Value
audio n/a
Description: Audio for this speaker.
Internal Parameter
Position
Type Default Value
worldposition_ geocentric (0,0,0)
Description: The X, Y, and Z position of the speaker relative to the
reference point. The coordinate system is the same as the one used in
the Feeders > AuralCuePos component (+X is forward, +Y is to the
left, and +Z is up).