Technical data

DOC-01-TELAS-CRG-4 ASTi ACE Studio Components Reference Guide Rev.M
112 Copyright © 2014 Advanced Simulation Technology inc.
Internal Parameters
EndBand1
-5
Type Default Value
float32 965.4772
Description: Specifies the end of the bandwidth affected by the
filter settings. Not adjustable. For BandPass, BandPassUnityGain,
and Notch filters this specifies the right -3 dB corner frequency in
hertz. For PeakingEQ filters this specifies the midpoint frequency in
hertz.
FilterType
1-5
Type Default Value
filter_type3 LowPass
Description: FilterType determines the type of filter applied to the
input signal. If no filtering is desired, FilterType should be set to
Off.
Order1-5
Type Default Value
filter_order _12dB_Per_Octave
Description: FilterOrder determines the order of the filter applied
to the input signal. 2
nd
, 4
th
, and 6
th
orders are available,
corresponding to 12, 24, and 36 dB per octave roll-off in LowPass,
HighPass, LowShelf, and HighShelf filters and 6, 12, and 18 dB per
octave roll-off in BandPass, BandPassUnityGain, Notch and
PeakingEQ filters (assuming QFactor is fixed at 0.7071). Generally,
the higher this control the steeper the roll-offs will be.
StartBand
1-5
Type Default Value
float32 258.9393
Description: Specifies the start of the bandwidth affected by the
filter settings. Not adjustable. For BandPass, BandPassUnityGain,
and Notch filters this specifies the left -3 dB corner frequency in
hertz. For PeakingEQ filters this specifies the midpoint frequency in
hertz.