Technical data

ASTi Telestra 4 Training Manual (Ver. 1, Rev. F)

9.2. Mixer

The mixer component provides controlled mixing of up to eight signals into a single, composite

signal. The mixer controls determine which of the eight signals should be mixed with both indi-

vidual and overall gain control. There is also a ninth signal that is always mixed into the output

signal and allows cascading of multiple mixer components.

1. Create a new Project and install.

2. In the Load, create a new Sim model and name it.

3. Open the new model and add two Audio > Wave components and name them

‘Sine_Wave’ and ‘Square_Wave.’

4. Then add an Audio > Mixer component and an I/O > ACU Channel component (name

them Mixer and ACUchannel_A).

5. Open the Sine_Wave and set the frequency (for example 400). Route the Sine_Wave out-

signal to the Mixer using signal1.