Technical data

ASTi Telestra 4 Training Manual (Ver. 1, Rev. F)

2.3.4. Crown

Amplifiers

The Crown

Power Amplifier provides the user with the power levels and features to meet audio

requirements for aural cue simulation. Each amplifier is a network component that integrates with

ASTi’s ACENet architecture. ASTi offers the CT 4200 4-channel amplifier in a 2U chassis and

the CT 8200 8-channel in a 3U chassis. This platform is for audio out only and is generally used

for aural cue programs.

The platform components consist of:

• Two Ethernet ports to the 100 Mbps network

• Four or eight output connectors (depending on the platform purchased)

• Mode switches for every two channels

• Channel level controls providing gain control

• Four or eight input connectors (depending on the platform purchased) Note: The input con-

nectors are not used in the ASTi system setup.

Status Indicator Lights Power

Figure 11: 4-Channel Amplifier Front Panel

dB 0

MAC ADDRESS

PART# 00000000AAAAAA

0000000000

120 V

00/00/0000

AC Power Cord Connector

Output Connector

Primary & Secondary Ethernet Ports

Channel Level Controls

Input Connector

Mode Switch

Figure 12: 4-Channel Amplifier Rear Panel