Technical data

ASTi Telestra 4 Training Manual (Ver. 1, Rev. F)
Copyright © 2010 Advanced Simulation Technology inc. 101
9.8. Comms Model Workflow using Helpers
The following outline guides the user through the workflow for creating a comms model using the
ACE Studio Helpers. This example assumes a level of familiarity with the ACE software.
1. Create a new Project and install.
2. In the tree view, under the Servers folder create a DIS_Gateway.
a. Set DIS version 4, 5, or 6.
b. Set the interface to eth0.
c. Set the DIS RX/TX Port (for example 53000).
d. Next to main set the outgoing destination address for DIS packets (for example
255.255.255.255). Select broadcast or multicast.
e. Select ‘OK.’