Technical data

ASTi Telestra 4 Training Manual (Ver. 1, Rev. F)

11.In the Operator2 folder, change the CommPanel radio bus to RadioBus2. Also

change the ACE-RIU component Channel to channel B (or another channel

with connected audio peripherals).

12.Open the Model Link Editor for Operator1 and link the following as shown below:

ACE-RIU using signals DigitalIn /PTT to the CommPanel

ACE-RIU using signals AudioIn /InSignal to the CommPanel

CommPanel using signals OutSignal/AudioOut to the ACE-RIU

CommPanel using signals SideSignal/AudioOut to the ACE-RIU

Note: The link connections may vary depending on ACENet device and PTT type.

Repeat these links for Operator2.

13. After all links are created apply the changes.