User guide

ASTi Telestra User Guide (Ver. 3, Rev. G.1)

Figure 87: Change IP Settings Screen

Note that this will only affect settings for ethernet card eth0. To change settings for eth1 or eth2,

you must use the RMS web interface. Specifying network information on this screen will change

eth0’s operational mode from “DHCP” to “ﬁxed”.

Specify the desired IP address, netmask, and gateway for the simulation network, pressing the

Enter key after each element. If you are unsure of these settings, contact your network administra-

tor for more information. Use the TAB key to highlight “OK”, and press the space bar or Enter

key to write the settings to Telestra’s hard disk; the system will then restart its network software.

Afterward, RMS can be accessed via its web-browser interface.