User's Manual

Astera LED Technology GmbH
AX1 Technical Reference Manual 2020-08-25
Page | 7
4.2 BATTERY
While running on battery, the light adjusts its output to meet the required minimum runtime.
It can be set by AsteraApp™ between one and twenty hours.
After Reset Settings (chapter 7.6), it defaults to 5h.
The battery is specified to last for 300 full discharge cycles. Its runtime will have decreased to
70% by then. To increase the battery life, it is recommended to recharge as early as possible
and not let the light run until the battery is depleted.
If operated below 20°C, the battery runtime may be slightly shorter than predicted. This is also
true if the lights are stored for a long time at cold temperature right before they are used.
The light is constantly monitoring the LED temperature and dims down the brightness if it
exceeds 65°C. That ensures a save and long-live operation but in a hot environment the
brightness might be slightly lower.
NOTE:
Always store the lights with full battery.
Depleted batteries must be recharged immediately, otherwise their performance will suffer.
ATTENTION:
The battery may be only replaced with an original Astera replacement battery.
4.2.1 STANDBY
By using the AsteraApp™, the light can be set to a special standby mode (chapter 8.14).
In that mode, its output is switched off, the CRMX receiver is powered down and it enters a
state of low power consumption.
A full battery will supply the Pixeltube ™ roughly 3 weeks in standby mode.
To leave standby mode, either do so by the AsteraApp™ or reset the light.
4.3 CHARGING
Charge the light immediately after use.
If charging in a carrying case, make sure the case is open. It is recommended to charge the
lights at an ambient temperature between 0°C and 35°C. A normal charge cycle will take
five to seven hours, but may take much longer if the light is hot (blinking orange).
The light is designed to be charged while powered off. If it is connected to the charger and
powered on, it may charge at reduced current if enough power is available and the battery
temperature is below 45°C.
To check the battery status and charging status refer to chapter 7.77.7.3.
4.4 AC WIRING
The light has an automatic battery bypass switch, so it can safely be used wired, this will not
cause wear to the battery.