User's Manual

Astera LED Technology GmbH
AX1 Technical Reference Manual 2020-08-25
Page | 27
8.14 ENTER AND LEAVE STANDBY
The standby is intended to be used between setup and event (see chapter 4.2.1).
After setup is completed, all lights may be switched to standby mode and woken up later
when the event starts. This ensures that no battery runtime is wasted.
This can be either done manually or automated.
Press the small arrow to
open the standby menu.
By pressing the “Now”
buttons, standby can be
switched on or off for all
currently targeted lights.
Any of the “Later” buttons
will require a time to be set.
The standby will be sched-
uled to the specified time.
NOTE:
While you are using the “Now” function, only those lights that are currently targeted
are addressed (see chapter 8.5 how to target lights).
The “Later” function always sends to the “All Lights” target!
NOTE:
To check if the light is completely powered off or only in standby mode, press the
power button shortly. If it stays dark it is powered off.