User's Manual

Astera LED Technology GmbH
AX1 Technical Reference Manual 2020-08-25
Page | 15
7.10 DMX ADDRESSING VIA BUTTON
It is possible to assign DMX addresses for 4 common profiles to AX1 Pixeltubes via the light’s
button and built-in accelerometer:
1) Set the AX1 to blue mode by holding down the button for 3 seconds
2) Shake the AX1 up and down a few times like a cocktail shaker
3) The AX1 will no longer blink blue completely, but only ¼ of it will be lit up.
4) The color of the ¼ tube will indicates the DMX profile. You may switch between pro-
files by shaking the tube again.
5) Cycle through the available DMX addresses by pressing the button
6) When the correct address is set, hold the button down again to latch it.
The below table shows the DMX addresses that can be selected.
DMX Fail, AC Fail and Dimmer Curve are all set to default settings when addressing this way.
Tube color
Profile
Address
42: RGB RGB
(Pixel = 16, Strobe = Off)
1
49
97
145
193
241
289
337
385
433
1: RGB
(Pixel = 1, Strobe = Off)
1
4
7
10
13
16
19
22
25
28
31
34
37
40
43
48: RGB CCT DIM IND
(Pixel = 16, Strobe = Off)
1
97
193
289
385
7: RGB CCT DIM IND
(Pixel = 1, Strobe = Off)
1
7
13
19
25
31
37
43
49
55
61
67
73
79
85