User's Manual

Astera LED Technology GmbH
AX1 Technical Reference Manual 2020-08-25
Page | 14
7.8 BLUE MODE / SHOW STATIC COLOR
In blue mode, the light shows a rapid blue blinking.
This mode is used to:
• Pair the light with an AsteraApp™
• Switch it to display a static color without the use of any remote control
To pair the light, make sure it is in blue mode (see chapter 7.6), then press the “Pair with
Lights” button in the AsteraApp™. More details on pairing can be found in chapter 8.1.
To set a static color, while in blue mode:
Press Button
Function
Press the button shortly to cycle between the predefined
colors. All previous STANDALONE settings are cleared to
default and the INPUT SELECT is latched to STANDALONE.
This is valid until the next power-up only. To make sure the
light also shows a static color after the next power up, set
INPUT SELECT to STANDALONE and not AUTO.
To exit Blue Mode and latch the chosen color, hold the
button until the blinking stops.
7.8.1 Predefined Colors
Color
Red
Green
Blue
RED
255
0
0
ORANGE
255
107
0
YELLOW
255
160
18
GREEN
0
255
0
CYAN
0
255
224
BLUE
0
0
255
VIOLET
127
84
255
PINK
255
53
119
2700K
255
166
70
3200K
255
178
89
4000K
255
193
115
5500K
255
211
150
6500K
255
219
167
7.9 TAP THE LIGHT (FOR ASTERAAPP™)
During certain tasks, like setting up the DMX or creating a set, the AsteraApp™ asks to tap a
light. In that case, the light will flash white shortly every two seconds.
Press Button
Function
Press the button shortly to “tap the light”.
The light will confirm with three bright white flashes.
The new configuration, like DMX address, set association
etc. is latched.
Alternatively you can use an ARC1 infrared remote to accept a setting. Aim it at the light and
press the POWER ON button of the ARC1 to accept the setting.