Operating instructions

23
Erecting Instructions
(1) Place the stand in position on the ground and hinge the three legs out into
horizontal position.
(2) Place the mast into the lower bearing, ensuring that the PTFE disk is in position.
(3) Remove the three struts from their stored position in the legs and fit them into the
holes provided in the upper bearings. Push the three attached R clips into holes
in struts.
(4) Lower the adjustable feed just sufficiently to prevent the stand from rocking and
to set the mast vertically. Lock the feet with thumbscrews provided.
(5) Turn the mast to the direction required and lock with the thumbscrew in the lower
bearing.
(6) For transit the legs can be folded into mast and clamped in position with R clips
as shown in Section AA.