User's Manual

Figure Status indication area

There are two modes in the status indication area. One is Access Point and

the other is Peer-to-Peer. At the same time, each mode allows users to opt the

WEP enable or WEP disable. When encryption is enabling, wireless client shall

offer the matched WEP key for key verification to connect the access point;

otherwise, the connecting will fail. According to the potential fact that WEP key

mismatch case may happen, WCM offer a sense of figures, which can help to point

out the status. The detailed description with the matched figure will be shown as

below.

Access Point / WEP disable

The receiver can receive

excellent signals. Encryption is

enabled and matched each other.

The receiver can not receive any

AP’s signal. Encryption is enabled

and matched each other.

Peer-to-Peer / WEP disable

The receiver can receive

excellent signals. There is no

encryption in use.

The receiver can not receive any

AP’s signal. There is no

encryption in use.

Peer-to-Peer / WEP enable / WEP match

The receiver can receive excellent

signals. Encryption is enabled and

matched each other.