Manual Part 2

FCC安全指示

本产品已经过＜Class B 数字装置＞测试及严格要求。此限制按照F C C规则的1 5个部分。这些限制是为了在居住环

境中安装任何设备，提供合理的保护，和对抗有害干扰而设计。若未按照指示正确的安装或使用，此设备可能会产

生或散发射频能源，并可能对电讯交通造成有害的干扰。但是，并不保证在特殊的安装中，不会产生干扰。

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the

interference by one of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party

responsible for compliance could void the user's authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and (2)

this device must accept any interference received, including interference that may

cause undesired operation.

IMPORTANT NOTE:

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment.

This device complies with FCC RF Exposure limits set forth for an uncontrolled

environment, under 47 CFR 2.1093 paragraph (d)(2).

This transmitter must not be co-located or operating in conjunction with any other

antenna or transmitter.

This device was tested for typical by stander conditions that may occur during use.

To comply with FCC RF exposure requirements a minimum separation distance of

1.5cm must be maintained between the user’s body and the device, including the

antenna.

Remark: Wireless USB Dongle is limited in Ch1~Ch11 by specified fireware controled in U.S.A.