User`s guide

30
How do I calibrate the touchscreen?
1
2
The touchscreen interprets your touch and moves the cursor where you move your finger. You can adjust or
“calibrate” your touchscreen for your individual touch from the Mercury Control Panel. Note: use your
finger or a stylus on the touchscreen; do not use sharp objects that can scratch or puncture it.
Click the Setup button on the Mercury
Control Panel (see page 11), then in the
Main Setup tab under Touchscreen click
Touchscreen Setup .
Click the Calibration tab at the top of the
window, then click the large calibration
target to start calibration. (The default
Calibration Type is 4-point. If this is not
appropriate, click Configure to change
the number of points.)
With your finger or a pointer, touch the
center of each crosshair as it appears.
Keep pressing on each target while the
prompt next to it indicates HOLD, then
stop pressing when the prompt changes
to RELEASE.
3
(To exit this screen without
recalibrating, simply wait for the
time-out indictor at the lower
left of the screen to count down.)