Assembly Instructions
AN2009-01
The Press-Out Process
Application Note 12 V2.2, 2015-02
Figure 8: Press-out tools for Easy1B (left illustration) and Easy2B (right illustration) modules
Just as for the press-in tools, CAD drawings can likewise be requested for the extrusion tools. The
drawing can be adjusted according to requirements and the tools produced by a manufacturer of
choice.
4.2 Press-Out Forces
To press a module out of a printed circuit board a force of approximately >40 N has to be applied for
each pin in the module. The extruding forces depend mainly on the diameter of the hole in the printed
circuit board.