Operator's Manual
Table Of Contents
- Remootio installation manual
- Step 1 - Unboxing
- Step 2 - Read the instruction manual carefully and follow the instructions
- Step 3 - Remove the plastic cover
- Step 4 - Connect the control output of the Remootio unit to the appropriate input terminals of your gate or garage door.
- Step 6 - Connecting an accessory
- Step 7 - Assemble the Remootio unit back together
- Step 8 - Powering Remootio
- Step 9 - Download the Remootio app
- Step 10 - Set up the Remootio unit
- Safety instructions
Step 4 - Connect the control output of the
Remootio unit to the appropriate input terminals of
your gate or garage door.
Based on the type of required control input, there are two types of gates and
garage doors:
• A single signal (impulse) can open, stop and close the gate or garage door
• Two separate signals (impulses) needed:
o One signal for opening
o and another signal for closing.
Single input type:
Different manufacturers name their control inputs differently. The most common
terms are as follows:
"CYC", "IMPULSE", "IMP", "KBUTT", "OPERATE", "OSC", "PB", "PP", "SBS", "SS",
"START", "STRT", "SW", "TRG", "WALL BUTTON", "WALL CONTROL".
Connect Remootio's control output to the appropriate input terminal of your
garage door / gate control board.
Please visit https://www.remootio.com/pages/compatibility and enter the make and
model of your gate or garage door to search for the correct wiring diagram.