Specifications

CL33700 PWI/PIP Series Cylindrical Lock

express written permission of Corbin Russwin, Inc. is prohibited.

5) Installation Instructions (Continued)

7. Install Spring Cassette and Route Wires:

a. Plug harness into wire from lock body (Fig. 7a, b).

b. Route lock body harness and ground wire (Fig. 7b Detail).

c. Install inside spring cassette, and tighten using two #12-24

screws provided (Fig. 7a).

d. Run wires through slots in edges of spring cassette (Fig. 7b)

Note: Do not run wires through center hole and be careful

not to pinch wires under spring cassette.

There are DOOR EDGE markings on the

cassette for orientation.

Wire Routing: This image shows wood door prep,

with wire run channel in inside face of door.

Door Status

Switch

Fig. 6a

6. Install Lock:

a. Feed lock body and wires through 2-1/8” diameter hole from outside

of door (Fig. 6a).

b. Be sure latch engages lock body (Fig. 6b).

IMPORTANT: Door must remain open during installation. Use door stop.

Fig. 6b

Fig. 7b Detail

Ground Screw

Wire Harness

Connector

and Wire

Ground Wire

Fig. 7a

Alternate construction would be a raceway through

the door core.