User's Manual

HF Mifare Easy Module V1.0
ACG Identification Technologies GmbH 28
7.3.4.3 Extended ID (default 0)
This setting does only affect the commands continuos reading (‘c’), select (‘s’) and
multi tag select (‘m’).
If set a the unique serial number of the transponder is extended by a single prefix
byte.
The values for the prefix byte are:
prefix description
01h MIFARE® Light Transponder
02h MIFARE® Standard Transponder
03h MIFARE® 4k Transponder
04h MIFARE® ProX Transponder
05h MIFARE® UltraLight Transponder
06h MIFARE® DESFire Transponder
FFh Unknown Transponder
7.3.4.4 Binary Timeout (default 0)
This flag is only interpreted if the reader operates in binary mode.
If the serial bus stays idle for more than 96 ms (no data is transmitted), the reader will
clear its command buffer and enter “Command Read” mode.
The “Command Read” mode means that the reader is waiting for valid data frames
(beginning with the STX code).
7.3.4.5 Multitag (default 0)
The Multitag flag will enable multi tag recognition in continuous read mode. All tags
are detected and displayed. Due to the more complex search algorithm the
continuous read command decreases its detection speed.