User's Manual Part 1

13,56 MHz Multitag Reader Module, Version 0.9v
ACG Identification Technologies AT Page 3
1 Scope
The 13,56 MHz Multitag Reader Module is a proximity reading device supporting a
wide range of 13,56 MHz tag. It supports ISO15693, Icode®, Tagit®, Mifare®
Standard, Mifare® Ultralight, SR176 and ISO14443 Type B cards. Using an external
antenna and a serial interface it can be easily connected to a PC. The Plug and Play
version has an integrated antenna and serial interface.
The first part of the documentation described general functions and memory
management of different tags. A listing of the memory map is given in detail if
necessary.
The second part lists the OEM module and describes the pin out.
The next chapter lists all commands and introduce to them. Each command is
explained and an example illustrates the usage. FAQs highlight general issues of the
handling of the 13,56 MHz Multitag Reader Module.
The appendices describes the Plug and Play Module, the custom coil design,
matching circuit and all steps to upgrade the Plug and Play board to +12V supply
voltage.
Additionally the use of the TempeSense® label is high lightened.
WARRANTY
THIS WARRANTY ONLY APPLIES TO THE H6160 DEVICE.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS
SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT
CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION.
CAUTION:
ANY CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE
PARTY RESPONSIBLE FOR COMPLIANCE COULD VOID THE USER’S
AUTHORITY TO OPERATE THE EQUIPMENT.