User's Manual Part 1

13,56 MHz Multitag Reader Module, Version 0.9v

ACG Identification Technologies AT Page 23

5.3.3.8 Start page (10h)

The EEPROM register defines the start page address in page read mode. To enable

this function the page read flag has to be set. See above protocol configuration

The reader will send the content of this page instead of the serial number. This mode

is only supported for ISO15693, Icode® and Tagit® tags. The reader does not check

the integrity of the page address. If an error occurs or a not valid page is read nothing

is returned.

Default value is 00h.

5.3.3.9 Number of pages (12h)

The number of pages describes how many following pages are read. The start

address is specified at EEPROM register 10h. The reader returns all pages and

sends in the end a <CR> + <LF>. In binary protocol mode each page is send

separately. No terminator is sent in the end.

Value 00h is reserved and should not be used.

Default value is 01h (one page is read).

5.3.3.10 User data (20h-FFh)

User data is free for use.